Published at Saturday, 30 March 2019. Industrial Machinery. By Alaine Mercier.
When you are making angled cuts simply align the sheet with the straight part of the miter gouge, and push it together with the miter gouge toward the blade. The saw will make the cut at an angle using the pivoting part of the miter gouge. Whereas fences allow you to make rip cuts, miter gouges provide you with a lot more options. You can make both square and angled cross-cuts as well as specialty cuts. In order to make a cross-cut, you need to slide the miter gouge back toward you. You then need to put the board against the straight part of the gouge.
I would also recommend you to look for switches that have a “sunk” or plastic cover which prevent you from turning the saw on accidentally. If you have kids running around the shop, consider a saw that comes with the ability to add a padlock. Actually, this comes in useful even if you don't have kids who are likely to gain access to your workshop.
After you have penciled in a line where you want the cross-cut to be made, align it with the blade. With the saw turned on guide the miter gouge forward until the cut is made while making sure the board is firmly in place against the straight edge of the miter gouge. One of the simplest cuts a miter gouge allows you to make is a square cross-cut. Simply set the miter gouge at 90 degrees or zero (depending on the markings), and push the board toward the blade. The result will be a board that is cut square. You can also make angled cuts by setting the miter gouge at an angle of up to 45 degrees.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.