Published at Saturday, March 30th 2019. by Alaine Mercier in Industrial Machinery.
Blade Teeth. Blade teeth the more teeth on a blade, the smoother the cut. The majority of blades have between 24 and 80 teeth, expect for blades specifically designed to cut through certain materials. Why would you go with more or fewer teeth? More teeth ensures that the cut is smoother, but it also means the cutting will be done more slowly. Fewer teeth means faster cutting, but the cut will be rougher. A word to the wise: Do NOT EVER attempt to make the cutting faster by pushing the wood onto the blade. The only thing this will do is cause kickback, which will eject the wood back at you at a high rate of speed and potentially hurt you severely. So just be patient.
Table Saw Safety Features. The most noticeable and probably the most important safety feature is the blade guard, because it's very effective at keeping your fingers away from the danger zone – the saw blade. Truth is though, that many woodworkers don't like the blade guard because they can't measure and see the cuts if it's attached, especially if the guard is not made out of Plexiglas. They also complain that things like changing the blade or removing stuck wood take more time, so they often decide NOT to use the blade guard.
If you encounter some resistance while moving the fence, I would advise you apply some sort of lubrication like wax. Factory or stock gouges are sometimes poorly made, and most people correct this by purchasing an after market miter gouge. However, if you get a table saw with a bad fence and leave it that way, it's not a shortcoming for which you can easily compensate.
Summary. I've kept this information relatively short and sweet, and you may have noticed I have neglected to mention some features which can be considered essential. However, fear not because I have plenty of other articles on my website designed to help you out with any question there might be in this respect. Of course, the best thing is you don't have to revert back to your main search engine because it's all here for you!
Another option to think about is the magnetic switch. You can read more about this on my page about safety features, but in short this will prevent the motor from dangerous automatic restarts after power interruptions. A magnetic switch is more common on cabinet saws, but you may want to consider an upgrade on your contractor as well.
One thing you have to keep in mind is to slide the wood a bit slower than you normally would because the movement of the gouge can move it out of place. To make sure this doesn't happen you can secure the board to the gouge using a clamp. Thanks to a miter gouge you can also make compound cuts. Compounds cuts are made by setting the miter gouge at a desired angle and bevel of the saw blade at the same time.
Dust Collection. Dust collection port Having sawdust all over your workshop and work surface is not only annoying, but it can make your job more difficult. It's much easier to work with wood if the table of the saw is smooth and clean. For this purpose most table saws have dust collection ports which can be attached to a vacuum. You may also come across saws that have a cloth pouch which you can attach to the saw so it collects all the dust in one “tidy” place.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.