Published at Wednesday, January 16th 2019. by Adriene Michel in Industrial Machinery.
For instance, the teeth on blades that cut through wood are made out of steel or carbon steel, which ensures their durability. Then there are masonry blades, which have diamond-tipped teeth, and you can also find blades that are made to cut through aluminum and steel. Such blades have teeth that are treated with hardened metal or tungsten carbide. Finally, there are blades designed to cut through PVC and acrylic materials, which have teeth made out of low-temperature tungsten carbide.
On/Off Switch. The on/off switchThese days, table saws come with an on/off switch that allows for easy access should the situation call for it. Usually these switches are located at the front of the saw, and preferably the off button should be large enough to be operated using your entire hand (protected of course), elbow, or even your knee. The easier it is to switch the table saw off, the better.
In Conclusion. As you can see there is not much to making rip, cross, or compound cuts. Using the fence and miter gouge is something you can get the hang of very quickly. But as easy as it is, the biggest mistake you can make is to become complacent when using a table saw. Remember you are handling a very powerful tool with an incredibly sharp blade that rotates at several thousand RPM. Always make sure to follow the safety measures, and you will be fine.
Elevation and Tilt Wheels. Elevations and tilt hand wheel The blade elevation hand wheel is usually located on the front of the saw and allows you to control the height of the blade, which effectively controls the depth of cut. In the case of 10-inch blades, the blade should be exposed around 3-5/8 inches at its maximum height which is sufficient to cut through a 4 x 4 in a single pass.
Accessory Storage. On board storage space another handy thing to have on your table saw is some on board storage space which allows you to store all the necessary tools and accessories you might need while operating a saw. Some units can even store fences, miter gouges, blades, and plenty of other stuff.
The Fence. One crucial component of every table saw along with the engine and blade is the fence. In fact, making a precise rip cut would be impossible without it. There is basically one type of fence most table saw manufacturers tend to use, but before we get into that let's go over the main characteristics a good fence should have. First of all the fence should allow for easy and hassle-free adjustment both horizontally and vertically. The fence should also sit on the rails firmly, and there should be NO “wiggle” room apart from the sliding.
Safety Considerations. When making cross-cuts avoid using the miter gouge and fence at the same time. Why? Because when you slide the board towards the saw using a miter gouge the board will most likely bind against the fence. At this point I should remind you this will most likely cause kickback which will throw the board back at you, and at high speed! This is something you definitely don't want to happen – ever. My advice would be to dismount the fence, or set it a decent distance away from the board.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.