Published at Wednesday, January 16th 2019. by Alaine Mercier in Industrial Machinery.
Dust Collection. Dust collection port Having sawdust all over your workshop and work surface is not only annoying, but it can make your job more difficult. It's much easier to work with wood if the table of the saw is smooth and clean. For this purpose most table saws have dust collection ports which can be attached to a vacuum. You may also come across saws that have a cloth pouch which you can attach to the saw so it collects all the dust in one “tidy” place.
Blade Sizing. Blade Sizes there are two ways table saw blades are sized: their outside diameter, and the diameter of the mounting hole. Most standard blades for table saws are 8, 10 or 12 inches in diameter, but there are blades as small as 3 3/8 inches in diameter and as large as 30 inches in diameter. The bigger ones are designed for specific commercial purposes, of course, but man, that's a big blade!
Push Stick; if you are not the lucky owner of a saw with the SawStop safety system, you are going to need a push stick, which comes in handy when you need to slide the wood through the blade. Having your hands too close to the saw blade is never a good thing, so it is a wise idea to rely on a push stick. You can get one at just about any shop that sells woodwork supplies, or make one yourself. There are plenty of tutorials on line to teach you how to do so.
When you are making angled cuts simply align the sheet with the straight part of the miter gouge, and push it together with the miter gouge toward the blade. The saw will make the cut at an angle using the pivoting part of the miter gouge. Whereas fences allow you to make rip cuts, miter gouges provide you with a lot more options. You can make both square and angled cross-cuts as well as specialty cuts. In order to make a cross-cut, you need to slide the miter gouge back toward you. You then need to put the board against the straight part of the gouge.
Miter Gouge. An Angled Cut Using a Miter Gouge. How does a miter gouge work? It's pretty simple. In essence it is a guiding device that moves inside the miter slot on the saw. The key component is the piece that sort of resembles a half-moon, and pivots around the point of its connection to the guide. Thanks to the locking mechanism you can choose any angle between 45 and -45 degrees.
Blade Materials. Diamond tipped masonry blades that are meant to cut plywood and hardwood are usually fabricated out of metal, but those that are designed to cut through harder materials require the use of even harder materials. The harder material is applied around the edge of the blade, with the metal core remaining intact.
Table Saw Safety Features. The most noticeable and probably the most important safety feature is the blade guard, because it's very effective at keeping your fingers away from the danger zone – the saw blade. Truth is though, that many woodworkers don't like the blade guard because they can't measure and see the cuts if it's attached, especially if the guard is not made out of Plexiglas. They also complain that things like changing the blade or removing stuck wood take more time, so they often decide NOT to use the blade guard.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.