Published at Friday, 18 January 2019. Industrial Machinery. By Agathe David.
Dust Collection. Dust collection port Having sawdust all over your workshop and work surface is not only annoying, but it can make your job more difficult. It's much easier to work with wood if the table of the saw is smooth and clean. For this purpose most table saws have dust collection ports which can be attached to a vacuum. You may also come across saws that have a cloth pouch which you can attach to the saw so it collects all the dust in one “tidy” place.
When you are making angled cuts simply align the sheet with the straight part of the miter gouge, and push it together with the miter gouge toward the blade. The saw will make the cut at an angle using the pivoting part of the miter gouge. Whereas fences allow you to make rip cuts, miter gouges provide you with a lot more options. You can make both square and angled cross-cuts as well as specialty cuts. In order to make a cross-cut, you need to slide the miter gouge back toward you. You then need to put the board against the straight part of the gouge.
Push Stick; if you are not the lucky owner of a saw with the SawStop safety system, you are going to need a push stick, which comes in handy when you need to slide the wood through the blade. Having your hands too close to the saw blade is never a good thing, so it is a wise idea to rely on a push stick. You can get one at just about any shop that sells woodwork supplies, or make one yourself. There are plenty of tutorials on line to teach you how to do so.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.