Published at Friday, 14 December 2018. Industrial Machinery. By Adelisa Legrand.
Concerning the two piece of plywood utilize to create this log‐cutting jig. The clamp will doze on the first pieces and the second is only to keep the clamp aside from the fence, so it doesn't catch. The bar portion of the clamp will lay on the edge of the plywood and will be secured to it at both ends.
1) A bar clamp lengthy enough to clamp both finale of the logs you are going to factory into boards.
Keep in mind, equipped with a three base clamp, this jig can be closed down to hold a log only a few inches lengthy. As such, you can utilize a four base bar clamp, if you don't mind the surfeit.
2) Two slice of 3/4" plywood a pair inches longer than the clamp you select.
The slice of 3/4" plywood the clamp ascend on is two inches broad. The second piece, which rides against the fence, is two and three quarters (2-3/4") wide and the same length as the other, give or take an inch or so.
3) Two 1-1/2" (1-1/2") screws to mount the clamp to the two inch (2") pieces of plywood.
4) Depending on how you want to join the two pieces of plywood together, you'll need about four 1-1/4" screws or nails. I also glued mine, but, with screws, that shouldn't be necessary.
To construct this jig, or sled, you need:
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.