Published at Thursday, 27 December 2018. Industrial Machinery. By Angelika Martin.
6. The upper guide procedure should be set to approximately 1/4″ or less above the height of the labor surface. If the guide is too high, the blade will not have the appropriate support and that could cause the blade to twist.
5. Because the main guard on a band saw is used to prevent excess blade exposure and is located above the guide procedures, it will be very significant to establish a boundary limit of 3″ from that blade that your pointers will not enter.
10. Do not attempt to cut inventory that does not have a flat bottom surface unless a suitable support is used or your labor is clamped to a sound surface of some sort. Always remember that the table is your control surface.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.