Published at Wednesday, 16 January 2019. Industrial Machinery. By Aiglentina Fournier.
One thing you have to keep in mind is to slide the wood a bit slower than you normally would because the movement of the gouge can move it out of place. To make sure this doesn't happen you can secure the board to the gouge using a clamp. Thanks to a miter gouge you can also make compound cuts. Compounds cuts are made by setting the miter gouge at a desired angle and bevel of the saw blade at the same time.
Elevation and Tilt Wheels. Elevations and tilt hand wheel The blade elevation hand wheel is usually located on the front of the saw and allows you to control the height of the blade, which effectively controls the depth of cut. In the case of 10-inch blades, the blade should be exposed around 3-5/8 inches at its maximum height which is sufficient to cut through a 4 x 4 in a single pass.
After you have penciled in a line where you want the cross-cut to be made, align it with the blade. With the saw turned on guide the miter gouge forward until the cut is made while making sure the board is firmly in place against the straight edge of the miter gouge. One of the simplest cuts a miter gouge allows you to make is a square cross-cut. Simply set the miter gouge at 90 degrees or zero (depending on the markings), and push the board toward the blade. The result will be a board that is cut square. You can also make angled cuts by setting the miter gouge at an angle of up to 45 degrees.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.