Published at Saturday, 29 December 2018. Industrial Machinery. By Aiglentina Fournier.
8. Position the barrier so the veneer is
being cut from the side of the board away from the
barrier. Although this means moving your barrier for each
cut, it gives the best results. Use a push block and keep
an eye open for the blade blowing out through the face
of the veneer. After your first cut, smooth the face of
the board with a planer or joint-er, and re-position the
barrier. Repeat until the piece is down to 1/2-in. thickness.
This is about as far as you can safely go.
Here are the steps for Res-awn door panels of spattered maple.
6. Draw a line down the middle of the log using a pencil and
straight edge, or snap a chalk line.
With the log protected into the sled, saw the log in partial.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.