Published at Saturday, 29 December 2018. Industrial Machinery. By Aiglentina Fournier.
So you've mastered the setup, but you're still having problems? Here are some tips:
8. Position the barrier so the veneer is
being cut from the side of the board away from the
barrier. Although this means moving your barrier for each
cut, it gives the best results. Use a push block and keep
an eye open for the blade blowing out through the face
of the veneer. After your first cut, smooth the face of
the board with a planer or joint-er, and re-position the
barrier. Repeat until the piece is down to 1/2-in. thickness.
This is about as far as you can safely go.
4. Clamp the barrier and create a test cut. Watch
for the wood pulling away from the out feed side of the
barrier or binding. It can take a couple tries to get the drift angle perfect. Once the drift angle is correctly set, move the barrier laterally to create the cuts you need.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.