Published at Thursday, 27 December 2018. Industrial Machinery. By Agathe David.
Two things are basic to properly functioning guides: feed rate and the amount of pressure applied to the inventory as it is pushed into the cutting path of the blade. Both feed and pressure will depend on the kind and thickness of wood, and the magnitude of the blade and speed that it is traveling. If the feed stuff is too rapid, the saw blade will chatter and screech as the back of the blade is pushed against the ball-bearing blade support at the back of the guide. If the inventory is fed too slowly into the blade, it could cause burning. Pushing too hard with one hand or the other could cause the blade to be pushed sideways, resulting in wear on the side guide procedure. This could cause the blade to dull or break and will more than likely result in an uneven cut.
Cutting privileged corners that are whichever radius-ed or rounded can finest be accomplished by re-cutting on whichever the drill press or the mortise machine. This is a particularly handy idea when you have close-fitting ranges or want a high degree of accuracy. When cutting outside radii it would be a good idea to create relief cuts to help retain the back of the blade from binding in the Cerf.
Before the saw is turned on, the upper guides have to be adjusted for the height of the wood being cut. A good rule is to set the guide around 1/4″ above the top edge of the inventory. Retain in mind that the upper and lower guides are not guards, but are guides. The function of these guides is to support the blade and to help it run true. They also retain the blade from drifting and deflecting during the cut.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.