Published at Saturday, 16 March 2019. Industrial Machinery. By Adriene Michel.
After you have penciled in a line where you want the cross-cut to be made, align it with the blade. With the saw turned on guide the miter gouge forward until the cut is made while making sure the board is firmly in place against the straight edge of the miter gouge. One of the simplest cuts a miter gouge allows you to make is a square cross-cut. Simply set the miter gouge at 90 degrees or zero (depending on the markings), and push the board toward the blade. The result will be a board that is cut square. You can also make angled cuts by setting the miter gouge at an angle of up to 45 degrees.
Dust Collection. Dust collection port Having sawdust all over your workshop and work surface is not only annoying, but it can make your job more difficult. It's much easier to work with wood if the table of the saw is smooth and clean. For this purpose most table saws have dust collection ports which can be attached to a vacuum. You may also come across saws that have a cloth pouch which you can attach to the saw so it collects all the dust in one “tidy” place.
If you encounter some resistance while moving the fence, I would advise you apply some sort of lubrication like wax. Factory or stock gouges are sometimes poorly made, and most people correct this by purchasing an after market miter gouge. However, if you get a table saw with a bad fence and leave it that way, it's not a shortcoming for which you can easily compensate.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.