Published at Saturday, 08 December 2018. Industrial Machinery. By Agathe David.
Band saw jig
It sounds crazy, but on most band-saws, you have to angle the stock to make a straight cut. Finding this 'drift angle' with setting the fence to match it is crucial to successful re sawing.
Start by marking a straight line on a scrap board, parallel to its edge. When you’ve cut distant enough to establish the float angle, hold the board in position plus transfer the angle to the saw’s table (left). Use the line you’ve marked to position the fence at the same angle (right). Then make test cuts as-well as adjust the fence as necessary to fine-tune the setup until the stock stays flush against the fence, without binding against it or wandering away.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.