Published at Saturday, 08 December 2018. Industrial Machinery. By Agathe David.
Start by marking a straight line on a scrap board, parallel to its edge. When you’ve cut distant enough to establish the float angle, hold the board in position plus transfer the angle to the saw’s table (left). Use the line you’ve marked to position the fence at the same angle (right). Then make test cuts as-well as adjust the fence as necessary to fine-tune the setup until the stock stays flush against the fence, without binding against it or wandering away.
Band saw fence
Set the Band saw Fence in the accurate Angle
Box in Long Boards
Re sawing lengthy boards is a breeze with this setup, because it automatically holds the board against the fence and then your hands are free to feed the board. Position the box in front of the blade in-conjunction with clamp it so the board fits snugly but slides between the box or the fence without binding or wobbling.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.