Published at Saturday, 08 December 2018. Industrial Machinery. By Agathe David.
Job Site Tips part I
How to Re saw Wood on a Band saw?
Re sawing is the process of cutting a board to make a thinner pieces of the same length plus width, opens up a world of woodworking opportunities. Re sawing permit you to create broad panels from narrow boards, thin pliable pieces for bent lamination, thin sheets of veneer, with even turn logs' into lumber. Like any woodworking competence, resewing takes time as-well as practice to master.
Start by marking a straight line on a scrap board, parallel to its edge. When you’ve cut distant enough to establish the float angle, hold the board in position plus transfer the angle to the saw’s table (left). Use the line you’ve marked to position the fence at the same angle (right). Then make test cuts as-well as adjust the fence as necessary to fine-tune the setup until the stock stays flush against the fence, without binding against it or wandering away.
Square a band-saw blade
Square the Band-saw Blade along with the Board
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.