Published at Monday, 14 January 2019. Industrial Machinery. By Aiglentina Fournier.
Table Inserts. throat plate Table inserts, or throat plates as they are usually called are nothing more than thin pieces of metal or wood, mounted around the blade and leveled with the surface of the table. This prevents small pieces of wood from falling inside the arbor.
When you are making angled cuts simply align the sheet with the straight part of the miter gouge, and push it together with the miter gouge toward the blade. The saw will make the cut at an angle using the pivoting part of the miter gouge. Whereas fences allow you to make rip cuts, miter gouges provide you with a lot more options. You can make both square and angled cross-cuts as well as specialty cuts. In order to make a cross-cut, you need to slide the miter gouge back toward you. You then need to put the board against the straight part of the gouge.
The blade tilt hand wheel is located on the side of the saw and allows you to tilt the blade up to 45 degrees away from the fence. The hand wheel which allows you to adjust the tilt of the saw blade is usually located on the left or right side of the unit depending on which way the arbor is made to tilt. Portable table saws usually don't give you as much control as professional cabinet saws though, and they often combine elevation and tilt adjustment in one wheel.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.