Published at Thursday, 03 January 2019. Industrial Machinery. By Aiglentina Fournier.
Step 14 of 14:
I checked it for square and was extremely surprised that it didn't want any adjustment. I also did a quick test cut. It worked great. I have since used it quite a bit and I really like it. This table creates an already useful tool that much more useful. And the best part was that all the substances were free.
As I specified in the start I will be entering this in the Metal Competition if you are so motivated. Thank you.
Step 10 of 14:
Here I used the bed rail/angle iron as a linear edge again. This cut is for the blade of the saw.
Step 11 of 14:
I test fit the saw but noticed that the saw body was stopping the saw from reaching its full depth. So I marked the area that was causing the rubbing and ground that down. Basically I tried to grind in the profile of the saw body so that I could get a tight fit against the table.
EDIT: I added a PDF scan of a the Milwaukee Band Saw profile. This way if you have the same saw you can print this out and usage it to lay out the profile on the table.
Step 9 of 14:
Since my welds were not that great I had to grind them down. The second picture shows me standing on the table. I just welded. In the construct video I also jump up and down on it to check the strength. It held up just fine.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.