Published at Wednesday, 16 January 2019. Industrial Machinery. By Aiglentina Fournier.
Blade Types. Rip vs. Crosscut blades the two basic types of table saw blades are rip and crosscut blades. Rip blades have a smaller number of teeth and larger gullets, which means there's more room to remove the shavings and dust. These blades are designed to cut along the grain of the material on the table, but although they cut faster, the resulting cuts are rougher.
Blade RPM. The maximum speed of a blade is usually expressed in RPM (revolutions per minute). One thing you need to look for is the speed of the table saw, which must never exceed the speed of the blade. Blades are designed to rotate at a certain speed, and using it on a table saw which exceeds that speed will cause the blade to break apart due to centrifugal force. This is pretty much everything you need to know about blades. If you decide you want to learn even more about blades and their properties, this should serve as a good base for you to build upon.
One thing you have to keep in mind is to slide the wood a bit slower than you normally would because the movement of the gouge can move it out of place. To make sure this doesn't happen you can secure the board to the gouge using a clamp. Thanks to a miter gouge you can also make compound cuts. Compounds cuts are made by setting the miter gouge at a desired angle and bevel of the saw blade at the same time.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.