Published at Wednesday, 13 March 2019. Industrial Machinery. By Alaine Mercier.
One thing you have to keep in mind is to slide the wood a bit slower than you normally would because the movement of the gouge can move it out of place. To make sure this doesn't happen you can secure the board to the gouge using a clamp. Thanks to a miter gouge you can also make compound cuts. Compounds cuts are made by setting the miter gouge at a desired angle and bevel of the saw blade at the same time.
Table Saw Safety Features. The most noticeable and probably the most important safety feature is the blade guard, because it's very effective at keeping your fingers away from the danger zone – the saw blade. Truth is though, that many woodworkers don't like the blade guard because they can't measure and see the cuts if it's attached, especially if the guard is not made out of Plexiglas. They also complain that things like changing the blade or removing stuck wood take more time, so they often decide NOT to use the blade guard.
Another option to think about is the magnetic switch. You can read more about this on my page about safety features, but in short this will prevent the motor from dangerous automatic restarts after power interruptions. A magnetic switch is more common on cabinet saws, but you may want to consider an upgrade on your contractor as well.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.