Published at Friday, 18 January 2019. Industrial Machinery. By Aiglentina Fournier.
After you have penciled in a line where you want the cross-cut to be made, align it with the blade. With the saw turned on guide the miter gouge forward until the cut is made while making sure the board is firmly in place against the straight edge of the miter gouge. One of the simplest cuts a miter gouge allows you to make is a square cross-cut. Simply set the miter gouge at 90 degrees or zero (depending on the markings), and push the board toward the blade. The result will be a board that is cut square. You can also make angled cuts by setting the miter gouge at an angle of up to 45 degrees.
Miter Gouge. An Angled Cut Using a Miter Gouge. How does a miter gouge work? It's pretty simple. In essence it is a guiding device that moves inside the miter slot on the saw. The key component is the piece that sort of resembles a half-moon, and pivots around the point of its connection to the guide. Thanks to the locking mechanism you can choose any angle between 45 and -45 degrees.
The Fence. One crucial component of every table saw along with the engine and blade is the fence. In fact, making a precise rip cut would be impossible without it. There is basically one type of fence most table saw manufacturers tend to use, but before we get into that let's go over the main characteristics a good fence should have. First of all the fence should allow for easy and hassle-free adjustment both horizontally and vertically. The fence should also sit on the rails firmly, and there should be NO “wiggle” room apart from the sliding.
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.