Published at Wednesday, March 27th 2019. by Adriene Michel in Industrial Machinery.
If you encounter some resistance while moving the fence, I would advise you apply some sort of lubrication like wax. Factory or stock gouges are sometimes poorly made, and most people correct this by purchasing an after market miter gouge. However, if you get a table saw with a bad fence and leave it that way, it's not a shortcoming for which you can easily compensate.
Push Stick; if you are not the lucky owner of a saw with the SawStop safety system, you are going to need a push stick, which comes in handy when you need to slide the wood through the blade. Having your hands too close to the saw blade is never a good thing, so it is a wise idea to rely on a push stick. You can get one at just about any shop that sells woodwork supplies, or make one yourself. There are plenty of tutorials on line to teach you how to do so.
Now, the most common type of fence found on table saws at the moment (especially the cabinet type) is the Biesenmeyer Commercial “T-square” fence, or in most cases manufacturer's copies and offshoots of that design. It's the most popular design because it is easy to adjust and operate, is made out of welded steel, accurate, and best of all there is not much that can go wrong with it.
Blade Types. Rip vs. Crosscut blades the two basic types of table saw blades are rip and crosscut blades. Rip blades have a smaller number of teeth and larger gullets, which means there's more room to remove the shavings and dust. These blades are designed to cut along the grain of the material on the table, but although they cut faster, the resulting cuts are rougher.
When you are making angled cuts simply align the sheet with the straight part of the miter gouge, and push it together with the miter gouge toward the blade. The saw will make the cut at an angle using the pivoting part of the miter gouge. Whereas fences allow you to make rip cuts, miter gouges provide you with a lot more options. You can make both square and angled cross-cuts as well as specialty cuts. In order to make a cross-cut, you need to slide the miter gouge back toward you. You then need to put the board against the straight part of the gouge.
Blade Materials. Diamond tipped masonry blades that are meant to cut plywood and hardwood are usually fabricated out of metal, but those that are designed to cut through harder materials require the use of even harder materials. The harder material is applied around the edge of the blade, with the metal core remaining intact.
Summary. I've kept this information relatively short and sweet, and you may have noticed I have neglected to mention some features which can be considered essential. However, fear not because I have plenty of other articles on my website designed to help you out with any question there might be in this respect. Of course, the best thing is you don't have to revert back to your main search engine because it's all here for you!
Any content, trademark’s, or other material that might be found on the Lipadoo website that is not Lipadoo’s property remains the copyright of its respective owner/s. In no way does Lipadoo claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 Lipadoo. All Rights Reserved.